Link check allows to automatically manage an eventual “True link backup” (onto ISDN line) in case of failure of the permanent VPN connection. When activating a packet voice, Abilis checks continuously the link using the below parameters:
LC-VALUESEnables/disables the use of the “Link-Check” protocol, and consequently the transmission of “Link-check” frames. The default value is SYS and means that parameters that are used are directly taken by NPV port. If LINK means that must be used local parameters;
TRYNumber of attempts considered for the state detection.
TOUTTimeout for the link-check reply reception.
DLY-UPInterval between attempts while state is UP.
DLY-TOUTInterval between attempts while state is UP and last try timed out.
THR-DNPercentage of successful attempts to declare state DOWN.
BURSTNumber of requests sent at each attempt.
BURST-DLYInterval between requests of the same attempt.
These parameters are in the link section:
[18:53:57] ABILIS_CPX:d npvle id:1
- Not Saved (SAVE CONF), Not Refreshed (INIT) ---------------------------------
Configured Links:1         Activated Links:8
ID:1    ACT:YES        LOG:SYS
        CLUS:NONE      MAXBW:NOMAX       MAXCON:NOMAX    GROUP:NONE
        ROLE:PEER      BCK:NO            CR:NO
        REMABILIS-ID:                    REMKEY:
        REMPORT:SYS                      LOC-KEY:
        LOCIP1:SYS                       REMIP1:#
        LOCIP2:SYS                       REMIP2:#
        V-TOS:SYS      C-TOS:SYS         V-TOUT:SYS      V-RED:SYS
        - Link-Check ----------------------------------------------------------
        LC-VALUES:LINK
        TRY:5          TOUT:5000                         BURST:1
        DLY-UP:10      DLY-TOUT:3        THR-DN:30       BURST-DLY:100