3.13. RIO connection
Prev Chapter 3. Physical connections Next

3.13. RIO connection

In this section it's shown how to connect a RIO to the Abilis CPX.

Follow the steps below to connect a RIO:

3.13.1. RIO Board-1 I/O connection

In this section it's shown how to connect a RIO Inputs/Outputs.

Figure 3.29. Pinout of RIO I/O board

Pinout of RIO I/O board

3.13.1.1. Connecting an external relay to Digital Output

The following figure explains how to connect an external relay to Digital Output of RIO.

Figure 3.30. Example of DOUT connection

Example of DOUT connection

3.13.1.2. Connecting a motion sensor to Digital Input

The following figure explains how to connect a motion sensor (BMD503) to Digital Input of RIO.

Figure 3.31. Example of DIN connection

Example of DIN connection

3.13.1.3. Connecting a DC motor to Relay Switch Port

The following figure explains how to connect a 12V DC motor to Relay Switch Port of RIO.

Figure 3.32. Example of Relay Switch Port connection

Example of Relay Switch Port connection

By enabling the digital output D-OUT-8 (ON), a contact is closed that short-circuits the respective 8-A and 8-B pins.

[Tip]Tip

Interesting chapters:

Section 2.14.2, “RIO - Remote I/O”;

Section 18.3.4, “Activating the RIO device”;

Section 79.2.1, “Example of LUA Script to pilot digital outputs of RIO device”;

Section 70.24, “Rio/Rvs configuration”.

3.13.2. RIO Sonoff connection

In this section it's shown how to connect a RIO Sonoff Inputs/Outputs.

3.13.2.1. RIO Sonoff Basic connection

The following figure explains how to connect a lamp to Digital Output of RIO Sonoff Basic.

Prev Up Next
3.12. RVS connection Home Chapter 4. Abilis firmware