Add the resource to the Abilis system with the following command:

[15:43:30] ABILIS_CPX:a res:vrrp

RES:VRRP ALREADY EXISTS

The VRRP resource may already exist in the system, but may not yet be active: set it active with the command:

[16:02:48] ABILIS_CPX:s act res:vrrp

COMMAND EXECUTED

	Caution
	After adding or setting the VRRP active, you must restart the Abilis to make the resource running (use the command warm start to reboot the Abilis).

[16:51:53] ABILIS_CPX:s p vrrp act:yes

COMMAND EXECUTED

[16:52:04] ABILIS_CPX:d p vrrp

RES:Vrrp - Not Saved (SAVE CONF), Not Refreshed (INIT) ------------------------
       ------------------------------------------------------------------------
       DESCR:Virtual_Router_Redundancy_Protocol
       LOG:NO         ACT:YES        mxps:256        TOS:0-N

Use the following command to display the parameters of the resource; by typing d p vrrp ? command it's possible to display the meaning of all parameters.

[16:52:04] ABILIS_CPX:d p vrrp

RES:Vrrp ----------------------------------------------------------------------
Run    DESCR:Virtual_Router_Redundancy_Protocol
       LOG:NO         ACT:NO         mxps:256        TOS:0-N

Meaning of the parameters:

The following command allows the administrator to change the configuration of the resource:

	Caution
	To activate the changes made on the upper case parameters, execute the initialization command init res:vrrp; while to set act the changes made on the lowercase parameters a save conf and an Abilis restart are required (i.e. With warm start command).