5.4. System accessing commands

5.4.1. LOGIN

This command shows the current privilege level, through which the User accessed the Control Port.

[11:38:04] ABILIS_CPX:login

Currently logged as USER

On the contrary, if an access level is specified, the command will login the User to the Control Port using the requested privilege.

[11:38:04] ABILIS_CPX:login super

Password:
Logged as SUPERUSER

5.4.2. LOGOUT

This command closes the current configuration session and prompts the login request.

If in the current configuration session the configuration was modified but not saved, the command displays a warning message and queries the User for proceeding with configuration saving or not.

[11:38:04] ABILIS_CPX:logout

THE CURRENT CONFIGURATION WAS MODIFIED BUT NOT SAVED.
PROCEED WITH 'SAVE CONF' COMMAND (N/Y/A)?y

VALIDATION IN PROGRESS ...
VALIDATION SUCCESSFULLY EXECUTED

SAVE EXECUTED

In case of the negative answer, the configuration session is closed, but the configuration isn't saved.

[11:38:04] ABILIS_CPX:logout

THE CURRENT CONFIGURATION WAS MODIFIED BUT NOT SAVED.
PROCEED WITH 'SAVE CONF' COMMAND (N/Y/A)?n
Logged as SUPERUSER

Any other answer makes the command to be aborted and the Control Port prompt to be shown again.

[11:38:04] ABILIS_CPX:logout

THE CURRENT CONFIGURATION WAS MODIFIED BUT NOT SAVED.
PROCEED WITH 'SAVE CONF' COMMAND (N/Y/A)?a

5.4.3. CLOSE / EXIT

This command closes the current connection to the Control Port.

If the User was connected to the Control Port through a TELNET port, then the command interpreter of the TELNET port will be prompted.

If the User executed this command through the off-line configurator, it will terminate the configurator and go back to the MS-DOS prompt.

If in the current configuration session the configuration was modified but not saved, the command displays a warning message and queries the User for proceeding with configuration saving or not.

[11:38:04] ABILIS_CPX:close

CLR 00 00

[192.168.0.201] TELNETS>