| 73.6. How to restart the Abilis through the command-line and the WEB interface | ||
|---|---|---|
 | Chapter 73. HowTo - Management |  |
| 73.6. How to restart the Abilis through the command-line and the WEB interface | ||
|---|---|---|
| | Chapter 73. HowTo - Management | |
A system restart is required in the following cases:
A new resource or device has been added (e.g. a res:ip-2 or a dev:bri4-1);
A new resource or device has been set active (e.g. s act res:ssh or s act dev:eth-2);
A lowercase parameter of a resource has been modified (e.g. s p dhcp mode:server).
It's possible to restart the Abilis in more ways:
Through the command-line:
warm start : it immediately executes the system restart.
warm start -delay <hh:mm> : it executes an automatic restart after <hh> hours and <mm> minutes. (e.g. warm start -delay 01:00).
warm start -nocall: it executes an automatic restart as soon as all CTI calls are closed.
![[Tip]](../images/tip.png) | Tip |
|---|---|
Interesting chapter: Section 5.13.25, “WARM START” |
Through the WEB interface. Refer to chapter Section 63.23.2, “Scheduled system reboot”.
| |  | |
| 73.5. How to remotely transfer files using a terminal emulator |  | 73.7. How to upgrade configuration files to newer firmware versions |