Add the resource to the Abilis system with the following command.

[14:35:31] ABILIS_CPX:a res:ospf

RES:Ospf ALREADY EXISTS 

The OSPF resource may already exist in the system, but may not yet be active: set it active with the command:

[14:35:35] ABILIS_CPX:s act res:ospf


COMMAND EXECUTED

	Caution
	After adding or setting the OSPF active, you must restart the Abilis to make the resource running (use the command warm start to reboot the Abilis).

[14:38:54] ABILIS_CPX:s p ospf act:yes

COMMAND EXECUTED

[14:39:17] ABILIS_CPX:d p ospf

RES:Ospf - Not Saved (SAVE CONF), Not Refreshed (INIT) ------------------------
       ------------------------------------------------------------------------
Run    DESCR:Open_Shortest_Path_First_Routing_Protocol
       LOG:DS       ACT:YES       max-lsa:1000     max-routes:500      
       RFC1583COMP:YES            OSPF-RID:AUTO (192.168.029.254)   ASBR:NO

	Note
	The "Not Saved (SAVE CONF)" message is displayed every time the port configuration is modified but not saved with the SAVE CONF command.

	Note
	The "Not Refreshed (INIT)" message is displayed every time the port configuration is modified but not refreshed with the INIT RES:OSPF command.

Use the following command to display the parameters of the resource; the command d p ospf ? displays the meaning of all parameters.

[14:52:12] ABILIS_CPX:d p ospf

RES:Ospf ----------------------------------------------------------------------
Run    DESCR:Open_Shortest_Path_First_Routing_Protocol
       LOG:DS       ACT:YES       max-lsa:1000     max-routes:500      
       RFC1583COMP:YES            OSPF-RID:AUTO (192.168.029.254)   ASBR:YES
       - ASBR section ---------------------------------------------------------
       LOCAL:NO            STATIC:NO            RIP:NO            
       LOCAL-METRIC:*      STATIC-METRIC:*      RIP-METRIC:*      
       DEF-METRIC:1      

Meaning of the most important parameters: