The example below shows how to configure the SMTP resource and to relay emails using an external SMTP server:

[10:21:28] ABILIS_CPX:s p smtp local-domain:test.lan relay-net:192.168.0.0/24 server:209.85.229.109
server-user:user server-pwd:password server-auth:digest


COMMAND EXECUTED

[10:25:52] ABILIS_CPX:d p smtp

RES:Smtp - Not Saved (SAVE CONF), Not Refreshed (INIT) ------------------------
       ------------------------------------------------------------------------
Run    DESCR:Simple_Mail_Transfer_Protocol
       LOG:NO         ACT:YES              tcp-locport:25    
       SRCADD:OUT-IP                       TOS:0-N
       ses-tot:10     SES-RESERVED-IN:2    SES-RESERVED-OUT:2    
       DT:120         MAX-IP-SES:2         MAX-RCPT:100           
       IPSRC:*                             IPSRCLIST:#
       LOCAL-DOMAIN:test.lan
       HELOHOST:noname
       wdir:C:\APP\MAIL\
       max-fail-notif:50                   MB-MAXSIZE:5000
       MSG-MAXSIZE:2000                    MB-MAXMAILS:1000       STORE-MB:NO
       -- Local SMTP relay ----------------------------------------------------
       RELAY-NET:192.168.000.000/24        RELAY-IPSRCLIST:#                   
       RELAY-AUTH:DISABLED
       QUEUE-LIFE-TIME:86400               MAIL-TRY-DELAY:300  
       -- External SMTP server for relay --------------------------------------
       SERVER:209.85.229.109  
       SERVER-TCP-PORT:25
       SERVER-AUTH:DIGEST                  SERVER-SECURITY:NONE  
       SERVER-USER:user
       SERVER-PWD:***
       -- SMS Gateway ---------------------------------------------------------
       SMS-GW:NO                           SMS-PERMIT:RELAY
       SMS-IP:#                            SMS-SENDER:#

This configuration allows the 192.168.0.0/24 net to use Abilis as SMTP Relay for both: local domain (test.lan) and non-local domain (through server 209.85.229.109). Use your account username and password to use the external SMTP server.

	Caution
	To activate the changes made on the upper case parameters, execute the initialization command init res:smtp; while to set act the changes made on the lowercase parameters a save conf and an Abilis restart are required (i.e. With warm start command).

	Note
	The value of SERVER parameter can be the FQDN of external SMTP Server or it's IP address.

	Tip
	Interesting chapter: Section 81.21, “How to configure CTISMS to send SMS via emails”.