| 79.12. How to replace USB Ethernet with USB GigaEthernet | ||
|---|---|---|
 | Chapter 79. HowTo - Management |  |
| 79.12. How to replace USB Ethernet with USB GigaEthernet | ||
|---|---|---|
| | Chapter 79. HowTo - Management | |
If the used port supports also USB 3.0, to replace a USB Ethernet
with USB GigaEthernet is needed to change the USBPORTID
parameter. This change is necessary because the USB GigaEthernet works
also with USB 3.0, and provide 10/100/1000Mbps. These changes are valid
for the reverse procedure, from USB GigaEthernet to USB Ethernet.
| s dev:ethusb-1 usbportid:none | Cancel the usbportid (e.g. ETHUSB-1 device). |
| init usbdev | Initialization of USB devices. |
| save conf | Save the configuration. |
![[Note]](../images/note.png) | Note |
|---|---|
The command init usbdev must be typed after replacing of modem. |
![[Warning]](../images/warning.png) | Warning |
|---|---|
If you are connected remotely to ABILIS through this line, it is better to restart the ABILIS instead of initialize the device, please refer to: Section 79.10, “How to automatically reassign the USBPORTID”. |
| Note |
|---|---|
The Abilis USB GigaEthernet is supported starting from Abilis firmware version 8.5. |
| |  | |
| 79.11. How to restart a USB device |  | 79.13. How to replace ADSL modem with ADSL2+ modem |