46.3. CTI Routings
Prev Chapter 46. SIP - Session Initiation Protocol Next

46.3. CTI Routings

Appropiate routings must be added in the CTI Router, in order to route the calls to and from the CTISIP resource.

The destination or the source of the SIP group appears as CtiSip (this is the default value).

To view all the configurable parameters type:

[13:47:29] ABILIS_CPX:d ctir

---+-----+-----------------+---------+--------------------+--------------------
PR |[DESCR]
   |TYPE |POI/SR   [SR]    |POO/DS   |CDI                 |CDO
ACT|NEXT       |LAST       |EEC |T301|CGI                 |CGO
EDT|SP   |SC   |DJ   |MJ   |FMDJ|FMMJ|SDI                 |SDO
   |SPOUT|SCOUT|DJOUT|MJOUT|LCS |LCST|SGI                 |SGO
   |                                 |RGI                 |RGO
   |FMRLY|FAXSP|MODSP|FMLVL|ECM |UDT |IG  |OG  |SG        |DL  |DH
   |CODERS
   |CODERSOUT
   |TI1 .. TI5
-------------------------------------------------------------------------------

The routing types involved with CtiSip are:

Table 46.2. CtiSip routing

TypeDescriptionTranscoding supported
VtoSVoice to SIPNO
CtoSCluster to SIPYES
HtoSH.323 to SIPYES
DtoSDISA to SIPYES
ItoSIAX to SIPYES
StoVSIP to VoiceNO
StoCSIP to ClusterYES
StoHSIP to H.323YES
StoDSIP to DISAYES
StoISIP to IAXYES
StoSSIP to SIPYES

[Tip]Tip

Transcoding is allowed when parameter CODERSOUT is different from *.

The transcoding is possible only for the coders supported by Abilis. To view them, type:

[14:09:52] ABILIS_CPX:d d ctisys

RES:CtiSys --------------------------------------------------------------------
       CTI_System_general_properties
       -- Number of simultaneous calls ----------------------------------------
                      | State: Alerting/Connected |        State: Any         |
       ---------------|---Current---|----Peak-----|---Current---|----Peak-----|
       TR             |           0 |           0 |           0 |           0 |
       DATA           |           0 |           0 |           0 |           0 |
       VtoCHISD       |           0 |           0 |           0 |           0 |
       CHISDtoCHISD   |           0 |           0 |           0 |           0 |
       CHISDtoV       |           0 |           0 |           0 |           0 |
       ALL            |           0 |           0 |           0 |           0 |
       ------------------------------------------------------------------------
       - Available coders -----------------------------------------------------
       -- Coder ---|-- Bit rates (kbps) --|-- Coder ---|-- Bit rates (kbps) --|
       G.711-A     |64                    |G.711-u     |64                    |
       TRANSPARENT |64                    |Spirit      |6.4, 7.2, 8, 8.8, 9.6 |
       ------------------------------------------------------------------------
       - Clock Sources for H100 cards -----------------------------------------
       CLK:INT
       - Clock Sources for NOT-H100 cards -------------------------------------
                          *** No NOT-H100 cards running ***
[Tip]Tip

For further information about transcoding refer to Section 45.3, “CTI Routings”.

Prev Up Next
46.2. CTISIP tables Home 46.4. Example of configuration