| 68.9. How to configure the Network Address Translation (NAT) | ||
|---|---|---|
 | Chapter 68. HowTo - Networking |  |
| 68.9. How to configure the Network Address Translation (NAT) | ||
|---|---|---|
| | Chapter 68. HowTo - Networking | |
Enter into the Abilis control-program or open the configuration file with the Console configurator and type the following commands.
| a res:nat or s act res:nat | Add the NAT resource. or If the resource already exists, set it active. |
| s p nat act:yes | Enable the NAT runtime functionalities. |
| Configure the NAT parameter for each IP resource. | |
| s p ip-n
nat:inside or s p ip-n nat:outside or s p ip-n nat:dmz or s p ip-n nat:vpn | NAT:INSIDE in a LAN,
AIPT (AIPT-BCK) resource or when Abilis behaves as a RAS
server.or
or NAT:DMZ in a LAN, AIPT (AIPT-BCK) resource when a DMZ is configured. or NAT:VPN in a LAN, AIPT (AIPT-BCK) resource when a VPN is configured. |
| save conf | Save the configuration. |
On a working Abilis, a system restart is required to make the NAT resource running.
| |  | |
| 68.8. How to configure the default IP route |  | 68.10. How to share a single Internet connection among multiple computers |