| 12.4. CTI GSM/UMTS ports diagnostics and statistics | ||
|---|---|---|
 | Chapter 12. UMTS BOX |  |
| 12.4. CTI GSM/UMTS ports diagnostics and statistics | ||
|---|---|---|
| | Chapter 12. UMTS BOX | |
To show the diagnostics of the CTI Ports the following commands are used:
Shows the following information:
USERName of the user assigned to this port. From 1 up to 32 ASCII characters or "#". The user must be present and it must not be already assigned to another port.
OPSTATEThe overall state of the port.
VOICE-STATEThe overall state of the GSM VOICE connection.
PDN-STATEThe overall state of the PDN (Packet Data Network) connection.
SMS-STATEThe overall state of the SMS channel.
NETThe currently used GSM network name.
ROAMINGShows if the currently used UMTS/GSM network is ROAMING type.
NET-MODEShows if the currently used network is GSM, UMTS or LTE.
SIGNALSignal quality (0 = -113 dBm or less, 1..30 = -111.. -53 dBm, 31 = -51 dBm, or greater 99 = not known or not detectable, 100 = N/A value when device isn't connected)
RXQUALThe value of BER (bit error rate) of the existing call.
IMEIInternation Mobile Equipment Identity number.
IMSIInternation Mobile Subscriber Identity number.
SIMSIM card identification number.
SMSCSMS Center number.
CODEC-ISO-BWIndicates the bandwidth of the AUDIO-CODEC ISO interface.
CELLShows if the hot-pluggable device is connected or not.
CELL-STATEShows the state of the USB interface of the GSM USB module.
CELL-ERRShows the reason of the not READY GSM module.
CODECShows if the hot-pluggable device is connected or not.
CODEC-STATEShows the state of the USB interface of the CODEC module.
CODEC-ERRShows the reason of the not READY GSM codec.
CONTROLShows if the hot-pluggable device is connected or not.
CONTROL-STATEShows the state of the USB interface of the CONTROL (PIC) module.
CONTROL-ERRShows the reason of the not READY GSM CONTROL (PIC).
Shows the diagnostics of a single port.
Diagnostics of a CTI GSM/UMTS port when no calls are running:
[09:21:45] ABILIS_CPX:d d ctip:502
CTIP:502 ----------------------------------------------------------------------
SIM_3204748405_(EX_RETENOI_3276270837)
USER:# OPSTATE:UP STATE:UP
------------------------------------------------------------------------
CH: STATE: [Q932-STATE:] CG: [SG:] CD: [SD:]
------------------------------------------------------------------------
*** All channels disconnected ***
------------------------------------------------------------------------
VOICE-STATE:READY PDN-STATE:READY SMS-STATE:READY
------------------------------------------------------------------------
NET:WIND NET-MODE:GSM ROAMING:NO
SIGNAL:22 SIGNAL-dbm:-69 RXQUAL:0
IMEI:357396012653490 IMSI:222881451579032 SIM:8939883345002210328
SMSC:+393205858500 CODEC-ISO-BW:1304000 SIM-SEL:FIX-SIM-A
CELL-MODEL:SIM5210 CELL-VER:V1.92 CELL-FEAT:VOICE,DATA,SMS
CELL:CONNECTED CELL-STATE:READY CELL-ERR:NONE
CODEC:CONNECTED CODEC-STATE:READY CODEC-ERR:NONE
CONTROL:CONNECTED CONTROL-STATE:READY CONTROL-ERR:NONEDiagnostics of a CTI GSM port when a call is running:
[09:23:17] ABILIS_CPX:d d ctip:502
CTIP:502 ----------------------------------------------------------------------
SIM_xxxxxxxxxx
USER:# OPSTATE:UP STATE:UP
------------------------------------------------------------------------
CH: STATE: [Q932-STATE:] CG: [SG:] CD: [SD:]
------------------------------------------------------------------------
1 07-LOC-ALERT 779 xxxxxxxxxx
------------------------------------------------------------------------
VOICE-STATE:IN-USE PDN-STATE:READY SMS-STATE:READY
------------------------------------------------------------------------
NET:WIND NET-MODE:GSM ROAMING:NO
SIGNAL:22 SIGNAL-dbm:-69 RXQUAL:0
IMEI:357396012653490 IMSI:222881451579032 SIM:8939883345002210328
SMSC:+393205858500 CODEC-ISO-BW:1304000 SIM-SEL:FIX-SIM-A
CELL-MODEL:SIM5210 CELL-VER:V1.92 CELL-FEAT:VOICE,DATA,SMS
CELL:CONNECTED CELL-STATE:READY CELL-ERR:NONE
CODEC:CONNECTED CODEC-STATE:READY CODEC-ERR:NONE
CONTROL:CONNECTED CONTROL-STATE:READY CONTROL-ERR:NONE![[Tip]](../images/tip.png) | Tip |
|---|---|
CODEC-ISO-BW shows the USB Isochronous bandwidth reserved on the USB controller to serve the CTIP. The audio codec always reserves the bandwidth of TWO CTIP even if one is disabled. |
This is what appears in the CTIR Connection (from PBX port group to GSM gateway):
[12:06:44] ABILIS_CPX:d ctic
SES ID Type Input Output PR State Cgi (Calling In) Cdo (Called Out)
---- ---- ---- -------- -------- --- ------ ------------------- --------------------
2 2 TR G1 502 3 ACTIVE 711 3482233445
Scanning available networks.
Example of NETSCAN:
[10:54:26] ABILIS_CPX:d d ctip:501 netscanTHE COMMAND WILL SEARCH ALL AVAILABLE NETWORKs. THIS OPERATION MAY TAKE FEW MINUTES. PROCEED ANYWAY (N/Y)?yCTIP:501 ---------------------------------------------------------------------- SIM_xxxxxxxxxx USER:# OPSTATE:UP STATE:UP ------------------------------------------------------------------------ CH: STATE: [Q932-STATE:] CG: [SG:] CD: [SD:] ------------------------------------------------------------------------ *** All channels disconnected *** ------------------------------------------------------------------------ VOICE-STATE:READY PDN-STATE:READY SMS-STATE:READY ------------------------------------------------------------------------ NET:WIND NET-MODE:GSM ROAMING:NO SIGNAL:22 SIGNAL-dbm:-69 RXQUAL:0 IMEI:357396012653300 IMSI:222881672196219 SIM:8939880367011211389 SMSC:+393205858500 CODEC-ISO-BW:1304000 SIM-SEL:FIX-SIM-A CELL-MODEL:SIM5210 CELL-VER:V1.92 CELL-FEAT:VOICE,DATA,SMS CELL:CONNECTED CELL-STATE:READY CELL-ERR:NONE CODEC:CONNECTED CODEC-STATE:READY CODEC-ERR:NONE CONTROL:CONNECTED CONTROL-STATE:READY CONTROL-ERR:NONE - Available Networks --------------------------------------------------- Status: Name: Code: Mode: CURRENT WIND 22288 GSM AVAILABLE WIND 22288 UMTS AVAILABLE 3ITA 22299 UMTS FORBIDDEN OMNITEL 22210 GSM FORBIDDEN OMNITEL 22210 UMTS FORBIDDEN TIM 22201 UMTS FORBIDDEN TIM 22201 GSM
![[Note]](../images/note.png) | Note |
|---|---|
If NETSCAN cannot be executed for any reason, e.g. because there is an active call or the module is disconnected, the message *** CANNOT EXECUTE NETSCAN *** is printed. |
To show the statistics of the CTI GSM/UMTS ports the following commands are used:
Shows the statistics of all the CTI ports such as the number of calls (successful and unsuccessful), the duration of the calls, the number of connection/disconnection of the GSM/UMTS device, the number of connection/disconnection of the audio-codec device and the number of CELL packets exchanged.
Shows the statistics of a single CTI port.
[16:14:19] ABILIS_CPX:d s ctip:501
CTIP:501 ----------------------------------------------------------------------
SIM-3883634235
USER:#
--- Cleared 0 days 19:47:27 ago, on 14/05/2015 at 19:23:22 -------------
Layer 3 Q.931
-----------|---INPUT---|--OUTPUT---|-----------|---INPUT---|--OUTPUT---|
FAIL-CALL | 0| 0|SUCC-CALL | 2| 0|
TIME-CALL | 48| 0|
------------------------------------------------------------------------
Layer 2 PDN
-----------|---INPUT---|--OUTPUT---|-----------|---INPUT---|--OUTPUT---|
PDN-CALL | | 0|PDN-CHAR | 0| 0|
PDN-TIME | | 0|PDN-FRM | 0| 0|
PDN-TIME-15| | 0|PDN-LOST | 0| 0|
| | |PDN-LONG | 0| 0|
------------------------------------------------------------------------
Layer 2 SMS
-----------|---INPUT---|--OUTPUT---|-----------|---INPUT---|--OUTPUT---|
SMS | 0| 0|SMS-FAIL | 0| 0|
------------------------------------------------------------------------
Layer 1 CELL (GSM/UMTS)
-----------|---INPUT---|--OUTPUT---|-----------|---INPUT---|--OUTPUT---|
CELL-DISC | 0| | | | |
CELL-CONN | 1| | | | |
CELL-MRST | 0| | | | |
CELL-ARST | 0| | | | |
CELL-HWRST | 0| | | | |
CELL-PCK | 68796| 34389| | | |
CELL-OVR | 0| | | | |
------------------------------------------------------------------------
CODEC-DISC | 0| |CONTR-DISC | 0| |
CODEC-CONN | 1| |CONTR-CONN | 1| |
CODEC-MRST | 0| |CONTR-MRST | 0| |
CODEC-ARST | 0| |CONTR-ARST | 0| |
CODEC-HWRST| 0| | | | |
CODEC-PCK | 71240766| 71241074|CONTR-PCK | 71254| 71255|
CODEC-OVR | 0| |CONTR-PCKH | 0| 0|
CODEC-UND | | 0| | | |
------------------------------------------------------------------------| |  | |
| 12.3. Last Calling Service for UMTSBOX |  | 12.5. How to update UMTSBOX-2 firmware |