In this example is shown how to block the connections from the IP address 192.168.20.1 to the Abilis HTTP service (i.e. IP address 192.168.20.253).

[15:54:19] ABILIS_CPX:a ipacl pr:0 type:deny prot:tcp sa:192.168.20.1 spo:* da:192.168.20.253 dpo:80

COMMAND EXECUTED

[15:54:21] ABILIS_CPX:d ipacl

IPRTR resource parameters:  ACL:YES       ACLBYPASS:#
                            COS:ENABLED   COSDFT:NORMAL

- Not Saved (SAVE CONF) -------------------------------------------------------
Tot-IPACL-Number:1

-------------------------------------------------------------------------------
PR: [DESCR:]
    TYPE:  SA:                             PROT:              ICMP-TYPE:
    IPCOS: DA:                             SPO:/PO:           DPO:
    TOS-O: TOS-I:                          SRES:              DRES:
           TI:
-------------------------------------------------------------------------------
0   DENY   192.168.020.001                 tcp                
    DFT    192.168.020.253                 *                  http(80)
-------------------------------------------------------------------------------

In the following example is shown how to assign the highest priority to the voice IP packets, when data and voice share the same line.

[16:16:35] ABILIS_CPX:a ipacl pr:0 type:permit ipcos:high tos-i:*-d prot:udp sa:* da:* sres:int spo:* dpo:*

COMMAND EXECUTED

[16:16:35] ABILIS_CPX:d ipacl

IPRTR resource parameters:  ACL:YES       ACLBYPASS:#
                            COS:ENABLED   COSDFT:NORMAL

- Not Saved (SAVE CONF) -------------------------------------------------------
Tot-IPACL-Number:2

-------------------------------------------------------------------------------
PR: [DESCR:]
    TYPE:  SA:                             PROT:              ICMP-TYPE:
    IPCOS: DA:                             SPO:/PO:           DPO:
    TOS-O: TOS-I:                          SRES:              DRES:
           TI:
-------------------------------------------------------------------------------
0   PERMIT *                               udp                
    HIGH   *                               *                  *
    *      *-D                             INT                *
-------------------------------------------------------------------------------

This rule means that all the packets with any IP source address and any UDP port, marked as “Minimum Delay” (TOS-I:*-D) must be sent with HIGH priority, leaving the same value of TOS (TOS-O:*).