72.14. How to configure the Network Address Translation (NAT)
Prev Chapter 72. HowTo - Networking Next

72.14. How to configure the Network Address Translation (NAT)

Enter into the Abilis control-program or open the configuration file with the Console configurator and type the following commands.

a res:nat

or

s act res:nat

Add the NAT resource.

or

If the resource already exists, set it active.

s p nat act:yesEnable the NAT runtime functionalities.
 Configure the NAT parameter for each IP resource.
s p ip-n nat:inside

or

s p ip-n nat:outside

or

s p ip-n nat:dmz

or

s p ip-n nat:vpn

NAT:INSIDE in a LAN, AIPT (AIPT-BCK) resource or when Abilis behaves as a RAS server.

or

NAT:OUTSIDE in a PPP or DL (DL-BCK) resource.

or

NAT:DMZ in a LAN, AIPT (AIPT-BCK) resource when a DMZ is configured.

or

NAT:VPN in a LAN, AIPT (AIPT-BCK) resource when a VPN is configured.

save confSave the configuration.

On a working Abilis, a system restart is required to make the NAT resource running.

Prev Up Next
72.13. How to configure the default IP route Home 72.15. How to share a single Internet connection among multiple computers