73.24. Sending Alarm through a call

73.24. Sending Alarm through a call
	Chapter 73. HowTo - CTI system

Suppose you have an IOBOX connected to the Abilis and you want to receive a call with a announcement when the gate will open. A digital sensor from the gate is connected at the Abilis in the Digital Input Line number 2. The alarm must be sent if the Digital Input 2 becomes ON.

The first step to follow is to prepare the sound files to be played by DISA. More information are in the section Section 51.8, “Message files”.

Enter into the Abilis control-program or open the configuration file with the Console configurator and type the following commands.

a res:ctidisa or s act res:ctidisa	Add the CTIDISA resource. or If the resource already exists, set it active.
s p ctidisa act:yes	Enable the CTIDISA runtime functionalities.
a res:alarm or s act res:alarm	Add the ALARM resource. or If the resource already exists, set it active.
s p alarm act:yes	Enable the ALARM runtime functionalities.
save conf	Save the configuration.
warm start	Restart Abilis.
s p ctidisa restricted-calling:yes	Reject calls also from calling numbers that aren't present in CTIDISA USERs CGI.
a ctidisa service:callback	Create a CTIDISA service named “callback”.
s ctidisa service:callback cb:yes	Enable Call Back for the service “callback”.
s ctidisa service:callback initdial:callback_sound	Set the name of the message group from which the message INITDIAL must be taken.
a ctidisa user:callback_user	Create a CTIDISA user named “callback_user”.
s ctidisa user:callback_user cb:yes	Enable Call Back for the user “callback_user”.
s ctidisa user:callback_user pin:4321	Set the Personal Identification Number for the user “callback_user”.
a alarm id:0 enabled:yes res:mfio io:d-in-2 trigger:on action:disa-cb or a alarm id:0 enabled:yes res:gpio-1 io:d-in-2 trigger:on action:disa-cb	Add a alarm what will make a call (CTIDISA Call Back) when the Digital Input 2 becomes ON (Command for the MFIO resource). or Add a alarm what will make a call (CTIDISA Call Back) when the Digital Input 2 becomes ON (Command for the GPIO-1 device).
s alarm id:0 disa-user:callback_user disa-pin:4321 disa-service:callback	Set the alarm parameters corresponding with the CTIDISA user and the CTIDISA service.
s alarm id:0 disa-cdo:555 disa-cgo:222	Set calling and called numbers for the call.
save conf	Save the configuration.
init res:ctidisa	Initialize the CTIDISA resource.
init alarm	Initialize the Alarm rules.

CTI routing configuration:

a ctir pr:0 poi:disa out:101 cdi:555	Add a CTI rule to route a call from DISA to a POTS phone which is connected to CTIP:101.
save conf	Save the configuration.
init ctir	Initialize the CTIR resource.

	Note
	The CTIDISA requires a separate licence in CPX

	Tip
Interesting chapters: Chapter 33, ALARM resource; Section 14.1.4, “Activation of the alarms for the MFIO/GPIO”.

Tip

Interesting chapters:

Chapter 33, ALARM resource;

Section 14.1.4, “Activation of the alarms for the MFIO/GPIO”.


73.23. How to activate On-Demand recording		73.25. Sending Alarm through SMS